WYSIWYG Web Builder





1/24th Production Rules - Winter Championship 2018/14

Body
Bodies must be 1/24th scale cars used at Le Mans in 1972 or earlier.  All bodies must have a suitable interior and at least 2 racing numbers. Bodies should be painted in a scale or prototypical colour scheme.(No 2 tone fades). Bodies can be from any manufacturer, but must be of reasonable scale appearance. The final decision regarding the eligibility of any body will made by the committee.
Chassis
Cars may use any 1/24th production chassis homologated for BSCRA racing. With the Parma Flexi 1 or Flexi 2 chassis, a hot wing may be fitted. No aluminium pans may be fitted to any car. No modifications except that pin tubes may be fitted and the rear and gear may be strengthened with piano wire not exceeding 16swg. EDM cut strengthening brackets may also be used as these make car construction simpler and are often supplied with chassis.

Lights
All cars must have lighting units fitted . The lighting units are a free choice, but must consist of a minimum of 2 white headlights and 2 red tail lights. It is recommended that the lights remain on after the car de-slots as this will help the marshals. During the sections run in the dark, at least 2 headlights and 1 tail light must be working. Any car not complying with this requirement must be repaired in race time. When the house lights are switched on, there is no requirement for any lights to be in working order. Lights may not be removed after the night section but do not need to be repaired if they no longer function
Chassis Front End
Hot wing may be soldered in place as this strengthens the chassis. Aluminium and rubber/plastic front wheels at least diameter of any make on 16g piano wire axle. In addition, 2 dimensional wheel stickers in line with BSCRA regulations may be used.

Chassis Rear End
Axles free choice.
Gears free choice of material, pitch and ratio.  The gear should not protrude below the chassis.
Rear axle bearings must be solid bush bearings. No ballraces. Rear Bearings may be soldered in position.
Tyres - Free choice. Max 21mm width.

Motor
Motor must be any motor from the following list. JK Hawk Retro, JK Hawk 6, JK Hawk 7 and Proslot Euro Mk1. FK type motors must be unopened and unmodified. Brush shunts may be fitted on other types of motors. Motors may be soldered in place and braced with a single piece of piano wire not exceeding 16swg.
.

Overall Width
83mm maximum.

By order of the committee - Pontefract Slot Car Club.